Volume 14, Issue 3 (September 2017)                   IJMSE 2017, 14(3): 54-63 | Back to browse issues page


XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Jafari Tadi A, Hosseini S, Naderi Semiromi M. INFLUENCE OF SURFACE NANO/ULTRAFINE STRUCTURE ACHIEVED BY DEEP ROLLING PROCESS ON PLASMA NITRIDING AND TRIBOLOGICAL PROPERTIES OF THE AISI 316L STAINLESS STEEL. IJMSE 2017; 14 (3) :54-63
URL: http://ijmse.iust.ac.ir/article-1-944-en.html
Abstract:   (19948 Views)

Influence of formation of surface nano/ultrafine structure using deep rolling on plasma nitriding and tribological properties of the AISI 316L stainless steel was investigated. Initially, the deep rolling process was carried out on the bar-shaped specimens at 15 cycles with 0.2 mm/s longitudinal rate and 22.4 rpm bar rotation. Then, plasma nitriding treatment was applied on the as-received and deep rolled kinds at 450 °C and H2-25% Vol. N2 gas mixture for 5­ h. Surface micro-hardness and un-lubricated pin-on-ring sliding wear tests were carried out on the as-received, deep rolled, plasma nitrided and deep rolled-plasma nitrided kinds. Results revealed that deep rolled-plasma nitrided kind is shown the highest wear resistance than the others, due to the further increased surface hardness achieved via the combined process.

Full-Text [PDF 6013 kb]   (4316 Downloads)    
Type of Study: Research Paper | Subject: Surfe coating and corrosion

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 All Rights Reserved | Iranian Journal of Materials Science and Engineering

Designed & Developed by : Yektaweb