Iranian Journal of Materials Science and Engineering
Iran University of Science & Technology
Wed, Nov 27, 2024
[Archive]
Volume 2, Issue 2 (Jan 2005)
IJMSE 2005, 2(2): 9-15 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
DEHGHAN MANSHADI A., ZAREI HANZAKI A., GOLMAHALLEH O.. AN INVESTIGATION TO BAINITE FORMATION MORPHOLOGIES IN NI-CR BEARING LOW CARBON STEELS THROUGH THERMOMECHANICAL PROCESSING. IJMSE 2005; 2 (2) :9-15
URL: http://ijmse.iust.ac.ir/article-1-34-en.html
URL: http://ijmse.iust.ac.ir/article-1-34-en.html
Abstract: (38091 Views)
The presence of bainite in the microstructure of steels to obtain a proper combination of strength and toughness has always been desired. The previous works however have shown that the presence of preferred bainite morphologies in the microstructure of any steel would not be readily accessible. In addition, the appearance of different bainite morphologies in the microstructure of any steel is dictated by different factors including the steel initial microstructure, austenitization characteristics, thermomechanical processing parameters and so on. Accordingly, in the present work, the effect of prior austenite grain size and the amount of austenite hot deformation on the bainite formation characteristics were investigated in 0.12C-2.5 Ni-1.2Cr steels. The results indicated that the prior austenite grain size and the amount of deformation in the austenite no-recrystallization region resulted in significant changes of the bainite formation kinetics and morphology.
Type of Study: Research Paper |
Subject:
Ceramics
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
