Volume 16, Issue 1 (March 2019)                   IJMSE 2019, 16(1): 49-60 | Back to browse issues page

XML Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Ngoret J, Kommula V. Microstructural Investigation into Premature Failure of Compressor Turbine (CT) Blade Material of High Pressure (HP) PT6A-114A Engine. IJMSE 2019; 16 (1) :49-60
URL: http://ijmse.iust.ac.ir/article-1-1121-en.html
Abstract:   (13275 Views)
This paper investigates premature failure of High Pressure (HP) PT6A-114A Compressor Turbine (CT) blades used for short-haul aircraft fleet at 6378 hours, contrary to 10000 hours pre-set by the manufacturer. The CT blades were sectioned both transversely and longitudinally and subjected to several microstructural examinations; X-ray Diffraction (XRD), X-ray Fluorescence (XRF), Energy Dispersive Spectroscopy-Scanning Electron Microscopy (EDS-SEM) of the tips, airfoils, as well as the bases. It was observed that from repeated elevated heating, incomplete solutioning and recrystallization of the substrate material, brittle carbides were initiated and developed. The tips were more affected, followed by the airfoils and least at the bases. Impingement of heat from the combustors on the CT blades led to rapid graining and rafting with eventual cracking upon cooling. The results further suggested that pores which are typically manufacturing defects were pronounced at the bases than either at the airfoils and the tips. However, contrary to the expectation that the bases would degrade more and rapider, a more near uniform distribution of the cuboidal phase was evident relative to the tips and airfoils, confirming that degradation of the CT blades originated from creep and fatigue.
Keywords: Inconel 713LC, XRD, XRF, EDS-SEM
Full-Text [PDF 1530 kb]   (3775 Downloads)    
Type of Study: Research Paper | Subject: Ceramics

Add your comments about this article : Your username or Email:

Send email to the article author

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 All Rights Reserved | Iranian Journal of Materials Science and Engineering

Designed & Developed by : Yektaweb