Volume 5, Issue 1 (winter 2008 2008)                   IJMSE 2008, 5(1): 29-36 | Back to browse issues page

XML Print


Abstract:   (33354 Views)
Abstract: Hardfacing is one of the most useful and economical ways to increase the service life of components subjected to abrasive wear. Iron based hardfacing alloys have long been considered as candidate coatings for wear-resistant applications in industry. In the present work two layer of Fe-34Cr-4.5C%wt hardfacing alloy was deposited on ASTM A36 carbon steel plates by SMAW method. The microstructure consists of large primary and eutectic M7C3 carbides, metastable austenite and small amount of secondary carbides. The microstructure was analyzed by optical and scanning electron microscopes. In the same condition of size, shape, distribution and volume fraction of carbides the as-welded matrix changed to martensite, tempered martensite and ferrite by heat treatment processes. The wear resistance was measured by pin-on-disk method under loads of 5, 10 and 20N and for sliding distance of 1500m. The results showed that the as-welded sample with austenitic matrix has the most and the ferritic matrix specimen has the least wear resistance. The predominate mechanisms for mass losses were determined to be micro-cutting, microploughing.
     
Type of Study: Research Paper |

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.