Volume 6, Number 4 (Autumn 2009 2009)                   IJMSE 2009, 6(4): 0-0 | Back to browse issues page


XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

B. Tolaminejad, A. Karimi Taheri, H. Arabi, M. Shahmiri. AN INVESTIGATION INTO THE EFFECT OF ECAE PROCESS ON MECHANICAL AND MICROSTRUCTURAL PROPERTIES OF MIDDLE LAYER IN COPPER CLAD ALUMINUM COMPOSITE. IJMSE. 2009; 6 (4)
URL: http://ijmse.iust.ac.ir/article-1-209-en.html

Abstract:   (10904 Views)
Abstract: Equal channel angular extrusion (ECAE) is a promising technique for production of ultra fine-grain (UFG) materials of few hundred nanometers size. In this research, the grain refinement of aluminium strip is accelerated by sandwiching it between two copper strips and then subjecting the three strips to ECAE process simultaneously. The loosely packed copper-aluminium-copper laminated billet was passed through ECAE die up to 8 passes using the Bc route. Then, tensile properties and some microstructural characteristics of the aluminium layer were evaluated. The scanning and transmission electron microscopes, and X-ray diffraction were used to characterize the microstructure. The results show that the yield stress of middle layer (Al) is increased significantly by about four times after application of ECAE throughout the four consecutive passes and then it is slightly decreased when more ECAE passes are applied. An ultra fine grain within the range of 500 to 600 nm was obtained in the Al layer by increasing the thickness of the copper layers. It was observed that the reduction of grain size in the aluminium layer is nearly 55% more than that of a ECA-extruded single layer aluminium billet, i.e. extruding a single aluminium strip or a billet without any clad for the same amount of deformation. This behaviour was attributed to the higher rates of dislocations interaction and cell formation and texture development during the ECAE of the laminated composite compared to those of a single billet
     
Type of Study: Research paper |

Add your comments about this article : Your username or email:
Write the security code in the box

Send email to the article author


© 2016 All Rights Reserved | Iranian Journal of Materials Science and Engineering

Designed & Developed by : Yektaweb